Open-source, self-sourced, and community-built printers — click any card for details and BOM access. For commercial/pre-assembled printers see .
Off-the-Shelf Printers
Commercial, pre-built, and semi-kit printers — click any card for specs, use cases, pros/cons, and how they compare to DIY builds.
📋 = Has BOM in Configurator
Toolhead Guide
Explore toolheads by machine — view pros, cons, and compatibility.
Multi-Material Units
Compare MMU systems and explore their features.
MCUs / Mainboards
Compare mainboard controllers for Klipper printers — stepper slots, CAN bus, processors, and compatibility.
SBCs (Single Board Computers)
Raspberry Pi, Orange Pi, BTT CB1/CB2, and other Klipper host boards — specs, OS downloads, and setup guides.
Toolhead Boards
CAN bus, USB, and passive toolhead boards — EBB, Nitehawk, H36, Hartk, and more.
Neopixels / LEDs
LED strips, Stealthburner LEDs, chamber lighting, and Neopixel configs.
Klipper Configurator
Assign components to MCU pins and generate a starter printer.cfg configuration.
Experimental Configuration Tool
This tool generates a starting-point Klipper printer.cfg configuration.
Output may contain errors or require adjustments. Always verify against official documentation before use.
When checked, the extruder motor, hotend heater, hotend thermistor, part cooling fan, hotend fan,
probe, and X endstop are assumed to be on the toolhead board (EBB36, Nitehawk, H36, etc.)
and will be omitted from the generated main MCU config.
TMC2209/2226 use UART communication. Verify the UART jumper is set on each driver socket.
Voron Tap uses the nozzle as the probe. Connect the Tap PCB signal wire to the Z endstop pin. activate_gcode and deactivate_gcode are not needed.
Search for optional hardware accessories to add to your configuration (neopixels, chamber heater, filament sensor, etc.)
Component Pin Assignments
Select the MCU slot for each printer component
Pin Conflicts Detected
Generated printer.cfg
# Select an MCU and Printer above to generate your configuration.
Slicer Config
Generate slicer start/end g-code and Klipper PRINT_START / PRINT_END macros for your printer and slicer combination.
Extruders
Complete guide to all extruders — Clockwork 2, Galileo 2, Orbiter, Sherpa, BMG, and more. Printed and commercial options.
Hotends
Complete guide to all hotends on the market — flow rates, max temps, and compatibility.
Manuals & Documentation
Build guides, firmware configuration, and reference docs.
Trusted Sellers
Community-vetted vendors for printer parts, electronics, and filament.
About
What this site is, how to use it, and who built it.
Contact Us
Get in touch — suggestions, bug reports, and community feedback welcome.
